Replacing the cartridge on your HP Deskjet 2130 printer is quite easy. You need not do much as you can follow the prompts given below to remove the cartridge once you view an error message on the control panel. The error message may state that the cartridge is low on ink or empty.
- Before replacing the ink cartridges, ensure that you insert paper into the HP Deskjet 2130 printer. Now, lift the input tray.
- Make sure that you discard the paper from the input tray that is different than the type of paper you want to load.
- Ensure that you slide the paper width guide as far as possible to the left and then proceed to insert a stack of paper as per specifications, into the input tray.
- Make sure that you push the stack into the tray until it stops and then slide the paper width guide to the right until it rests at the edge of the paper.
- Now, lower the output tray and pull out the output tray extender.Make sure that you replace one or both empty ink cartridges.
- Make sure that you press the Power button to switch on the printer if it is switched off.
- Now, lower the output tray, then reach inside the printer and then grasp the handle.
- Make sure that you lower the ink cartridge access door to open it. This may allow the carriage to move to the center of the HP Deskjet 2130
- Now, lightly press down on the ink cartridge to release it and then carefully pull the ink cartridge out of its slot.
- Take out one of the new ink cartridges from its package. Make a note that you should touch only the black plastic on the ink cartridge.
- Discard the plastic tape. It is advisable to not replace the protective tape on the contacts.
- Make a note that mishandling the above parts can result in clogs, ink failure and bad electrical connections.
- Carefully hold the ink cartridge by its sides with the contacts toward the printer and then place the HP Deskjet 2130 ink cartridge into its proper slot.
- Check if the black ink cartridge goes into the right slot and the tri-color ink cartridge goes into the left slot.
- Now, slide the new ink cartridge at a slight upward angle into the empty slot and then carefully push the ink cartridge until it snaps into place.
- Make sure that you repeat these instructions to install the other ink cartridge if necessary. Now, close the ink cartridge access door.
- Note that to achieve the best print quality, it is necessary to align the ink cartridges.
- Once you load the paper into the printer, the printer may automatically print an alignment page.
- Raise the scanner lid and then place the alignment page with the print side down on the scanner glass.
- Make sure that you position it according to the engraved guides around the glass and then close the scanner lid.
- Now, ensure that you press the Start Copy Black button or the Start Copy Color button on the control panel of the printer.You may notice that the HP Deskjet 2130 printer aligns the ink cartridges.
For any information or support, do not hesitate to reach our veterans on the Toll-free number. We are here to provide you instant solutions. 123.hp.com/dj2130
Advertisements Share this:
